How to perform a digital nerve block
Source
Surgeon:
Hannu Kuokkanen (plastic surgeon)
To access the full video and additional content on this subject, log in or subscribe
Summary
Focus: Local anesthesia for finger procedures.
Key elements: Small-gauge needle use, injection during needle advancement, bilateral finger block, waiting 15 minutes, and testing anesthesia at the fingertip.
Indications and Clinical Context
General
Medical experts: Hannu Kuokkanen (plastic surgeon), Jenni Liikanen (orthopedic resident)
Name of Procedure: Finger Nerve Block
Goal of Operation
Perform local anesthesia to facilitate procedures of the finger such as wound or tendon suturing, finger amputation, or fracture treatment.
Problem
Pain management in finger procedures
Key Anatomical Structures
Digital nerves
Palmar digital nerve (proper digital nerve)
Dorsal branches
Dorsal digital nerve
Digital arteries
Proximal phalanx
Step-by-Step Technique
Use a small-gauge needle to minimize pain. Preferably, use a Luer-lock syringe, so that the needle is screwed onto the syringe and will not come off. The local anesthetic used is usually 10–20 mg/ml (1–2%) lidocaine without adrenaline.
Firmly grasp the finger and tighten the skin with your fingers to prevent the skin from slipping.
Puncture the skin and, immediately after skin puncture, start injecting a small amount of anesthetic so that the tissue where the needle is advancing is already pre-anesthetized, reducing the patient’s pain. The anesthetic solution itself also pushes the nerves and vessels aside, and there is less risk of, e.g., puncturing the needle painfully to the digital nerves.
Gently inject a small amount of anesthetic each time you advance. Advance close to the periosteum of the proximal phalanx and all the way very close to the palmar skin, so that the anesthetic also numbs the palmar branches of the digital nerves.
As you withdraw the needle, inject more anesthetic to make the skin bulge. Here, a few millilitres of anesthetic solution have been injected.
Repeat the procedure on the other side of the finger.
Wait for 15 minutes and test the anesthesia with a needle prick to the tip of the finger.
Log in or subscribe to access full content and see all the images.
To access the full video and additional content on this subject, log in or subscribe
Piftalls and Complications
Pitfalls
Careless Tissue Handling
A finger nerve block is usually quite painful to the patient. To relieve the pain, advance determinably through the skin and, immediately after passing the skin, start injecting the anesthetic. This way, the soft tissue where the needle is advancing is pre-anesthetized, causing less pain. In addition, the anesthetic solution itself also pushes the nerves and vessels aside, decreasing the risk of puncturing them and causing excess pain and/or bleeding.
Being Too Hasty
It is essential to wait about 10–15 minutes to give time for the anesthesia to work before the procedure.
Complications
Nerve or Vessel Injury
There is a risk of puncturing the digital nerve or digital artery with the needle. Puncturing the nerve is extremely painful to the patient. It may also cause prolonged pain in the form of neuropraxia (segmental demyelination of the nerve).
Puncturing the artery causes excess bleeding and risk of injecting the anesthetic into the vessel. You can minimize these risks by injecting the anesthetic immediately after passing the skin so that the anesthetic solution itself pushes the nerves and vessels aside.
Neurolysis
Neurolysis is a rare complication due to the injected solution causing chemical injury. Always check yourself that you are injecting the right local anesthetic with the right concentration.
FAQ
What is the goal of a finger nerve block?
The goal is to perform local anesthesia to facilitate procedures of the finger such as wound or tendon suturing, finger amputation, or fracture treatment.
Which local anesthetic is usually used?
The local anesthetic used is usually 10–20 mg/ml (1–2%) lidocaine without adrenaline.
Why is anesthetic injected immediately after skin puncture?
Injecting anesthetic immediately after skin puncture pre-anesthetizes the tissue where the needle is advancing, reducing the patient’s pain. The anesthetic solution itself also pushes nerves and vessels aside.
How long should you wait before testing the anesthesia?
Wait for 15 minutes and test the anesthesia with a needle prick to the tip of the finger.
To access the full video and additional content on this subject, log in or subscribe